• 1x Display Frame
• 1x Frame Cap
• 2x Display Feet
• 3x Feet Screws
• 4x Slatwall Hangers
• 1 x Dual-sided Daggerfish Poster

In addition to these components, you will need the following tools:

• 1x Philips-head screwdriver (Size #2)

Step 2: Choose Display Front

Your display frame should be almost identical on both sides. Choose whichever side you prefer for the front and place it face up on a work surface with the bottom towards the edge of the table.

Step 3: Install Feet

Slot the wooden feet along the bottom of the frame with the longer side facing the front of the display. Align the hole in the bottom of each foot with the screw insert on either side of the frame. Screw in the feet using the feet screws and a #2 Philips-head screwdriver (this is the most common size of a Philips head). Tighten until snug; do not overtighten. 

Step 4: Insert Slatwall Hangers

Slide the four slatwall hangers into the slots along the top of the frame, and lever them down to lock in place.

Step 5: Insert Poster

Choose the appropriate side for the poster front and slide the poster along the grooves on the sides and bottom of the display frame. Ensure the poster is fully seated into the bototm groove before installing the frame cap.

Step 6: Install Frame Cap

Align the holes in the frame cap with the posts on either side of the display frame, and ensure the poster is properly aligned with the groove in the frame cap. Slide the cap down as far as it will go.  

Step 7: Completed Display

Your display is now assembled! Place it in a prominent place in your store and add your Daggerfish products to the slatwall hangers